Settings chart
Creality Falcon2 Pro settings for Veg-tan leather
To engrave Veg-tan leather on the Creality Falcon2 Pro (22W module), start at 18% power, 6000 mm/min, 1 pass. To cut 0.65 mm Veg-tan leather, use 100% power at 2000 mm/min for 1 pass. These come from the manufacturer's published table; run a test grid before a real job.
Starting points, not gospel. Rows marked “starting point” are either copied from the manufacturer’s published table (linked below) or are our editorial estimates from typical diode results. Neither has been bench-tested by us yet. Run a small power/speed test grid on your own sheet before a real job — batch, humidity and focus all shift the result.
| Module | Job | Thickness | Power | Speed | Passes | LPI | Air | Source | Status |
|---|---|---|---|---|---|---|---|---|---|
| 22W | Engrave | 0.65 mm | 18% | 6000 mm/min | 1 | — | — | Manufacturer | Starting point |
| 22W | Cut | 0.65 mm | 100% | 2000 mm/min | 1 | — | — | Manufacturer | Starting point |
| 40W | Engrave | 0.65 mm | 12% | 6000 mm/min | 1 | — | — | Manufacturer | Starting point |
| 40W | Cut | 0.65 mm | 70% | 4000 mm/min | 1 | — | — | Manufacturer | Starting point |
Manufacturer sources: Creality official Falcon2 40W table (Falcon2 Pro uses the same 22W/40W modules)
How to use this chart
- Focus first. Set focus on the material surface with the brand's focus tool or the fixed-focus spacer. A 0.5 mm error halves cutting ability.
- Run a test grid. A 5×5 grid of power (20–100%) against speed (cut: 100–1000 mm/min; engrave: 1000–6000 mm/min) on your actual sheet takes ten minutes and saves a ruined blank.
- Add passes before power. If a cut doesn't release, add a pass. Extra power at low speed just chars edges.
- Air assist on for cuts. It clears smoke from the kerf and keeps the lens clean; it is usually off or low for engraving to avoid blowing dust into fine detail.
Frequently asked questions
Why does my Veg-tan leather cut not go through at these settings?
Focus is the usual culprit: set the focus at the material surface (or 1/3 into thick stock), check the lens for smoke film, and confirm the belt tension. Then add one pass before adding power.
Should I change speed or power first?
For engraving, change speed and keep power moderate — it protects the diode and reduces charring. For cutting, run at 100% and tune speed and passes.
Do these settings transfer to another machine?
Only roughly. The Creality Falcon2 Pro module power (22W / 40W / 60W) and spot size drive the numbers. Use our page for your exact machine.